 |
| Quantity: | |
|---|---|
WP63 type pneumatic hydraulic pump
万达
Product Description
Number of circuits | Loop form | Loop assignment usage |
1 | C | Loop use and clamping upper mold |
Loop use and clamping lower mold | ||
Loop usage and simultaneous clamping of upper and lower molds | ||
D | Loop use and die lifter | |
2 | 2C | One loop uses and clamps the upper mold, and the other loop uses the lower mold. |
CD | One circuit is used to clamp the upper and lower molds at the same time, and the other circuit is used to hold the mold lifter. | |
3 | 2CD | One circuit is used for clamping the upper mold, another circuit is used for the lower mold, and the third circuit is used for the mold lifter. |
4 | 3CD | Two circuits are used to hold the upper mold in a cross mode, another circuit is used to hold the lower mold, and the fourth circuit is used to hold the mold lifter. |
Pneumatic hydraulic pump combination/model: WP63
Schematic diagram of pneumatic pump part names:
Oil pressure flow meter:
Specification table: WP-63 pneumatic hydraulic pump appearance dimensions:
WP63 series specifications:
model | Number of circuits | A | B | Full fuel tank capacity (L) | Available capacity (L) | WeightKg | Use oil |
WP63□□U | 1 | 353 | 393 | 6 | 4.7 | 23 | National standard hydraulic oil ISOVG32 VG68 |
WP63□□U | 2 | 353 | 493 | 6 | 4.7 | 21 | |
WP63□□U | 3 | 423 | 463 | 7.5 | 5.9 | 35 | |
WP63□□U | 4 | 493 | 533 | 9 | 7.1 | 43 |
WP63 series | Output when air pressure is 5 kg/cm² | Boost ratio |
WP6306U | 420 (kg/cm²) | 1:84 |
WP6307U | 300 (kg/cm²) | 1:60 |
WP6308U | 250 (kg/cm²) | 1:50 |
WP6309U | 200 (kg/cm²) | 1:40 |
WP6310U | 150 (kg/cm²) | 1:30 |
WP6312U | 100（kg/cm²） | 1:20 |
WP6314U | 80（KG/cm） | 1:16 |
WP6316U | 50（KG/cm） | 1:10 |
