Views: 2 Author: Site Editor Publish Time: 2023-11-30 Origin: Site
Uses of hydraulic press:
It is widely used in the processing of spare parts in the automobile industry and the shaping, blanking, calibration of various products in various industries, as well as the pressing, embodiments and forming of parts of shoes, handbags, rubber, molds, shafts and bushings, the bending, embodiments and sleeve drawing of plate parts, etc. Washing machine, motor, automobile motor, air conditioning motor, micro motor, servo motor, wheel manufacturing, shock absorber, motorcycle and machinery industries.
Safe operation of hydraulic press:
1. The operator of the hydraulic press must be trained to master the performance and operation technology of the equipment before it can operate independently.
2. Before operation, all kinds of debris on the mold should be cleaned and any dirt on the hydraulic press rod should be wiped.
3. The hydraulic press installation mold must be carried out in the case of power failure, and it is forbidden to collide with the start button, handle and foot on the foot switch.
4. Install the upper and lower mold alignment, adjust the mold gap, do not allow unilateral deviation from the center, confirm that the mold is fixed and then test the pressure.
5. Before the hydraulic press works, start the equipment idling for 5 minutes, and check whether the oil tank level is enough, whether the oil pump sound is normal, whether the hydraulic unit and the pipeline, the joint, and the piston have leakage phenomenon.
6. Start the equipment to test the pressure, check whether the pressure reaches the working pressure, whether the equipment is normal and reliable, and whether there is leakage phenomenon.
7. Adjust the working pressure, but should not exceed 90% of the rated pressure of the equipment, test a workpiece, and then produce after passing the inspection.
8. For different hydraulic press profiles and workpieces, when pressing and correcting, the working pressure and pressure of the press, the number and time of holding pressure should be adjusted at any time, and ensure that the mold and workpieces are not damaged.
9. When the body pressure plate is sliding up and down, it is strictly prohibited to put the hand and head into the working part of the pressure plate and mold.
10. It is strictly prohibited to knock, stretch, weld, bend, twist and other operations on the workpiece at the same time of pressure.
11. No smoking, welding and cutting, fire, inflammable and explosive items shall be stored around the hydraulic press. Take good fire prevention measures.
12. After the hydraulic press is finished, the power supply should be cut off, the hydraulic rod of the press should be wiped clean, the lubricating oil should be added, the molds and workpieces should be cleaned and placed neatly.
